Turn on the status line

The plugin's hooks already record every run. The status line itself is the one thing a plugin cannot switch on: Claude Code reads statusLine only from the user's own settings. This skill adds that entry.

Steps

1. Check jq is installed (command -v jq). The status line and the hooks need it. If it is missing, tell the user how to install it (brew install jq, apt install jq) and stop.

2. Check the script exists: ${CLAUDE_PLUGIN_DATA}/statusline.sh. The plugin copies it there at the start of every session, so it survives plugin updates. If it is missing, copy it now: mkdir -p "${CLAUDE_PLUGIN_DATA}" && cp "${CLAUDE_PLUGIN_ROOT}/statusline.sh" "${CLAUDE_PLUGIN_DATA}/statusline.sh".

3. Read ~/.claude/settings.json. If it already has a statusLine entry that is not this one, show it to the user and ask before replacing it.

4. Ask whether to show git information: nothing, everything (--git), or a comma list of repo, branch, worktree (--git repo,branch).

5. Set the entry, keeping everything else in the file as it is:

   "statusLine": {
     "type": "command",
     "command": "bash \"${CLAUDE_PLUGIN_DATA}/statusline.sh\"",
     "refreshInterval": 2
   }
   

   Append the git option inside the command when the user chose one, for example bash \"${CLAUDE_PLUGIN_DATA}/statusline.sh\" --git branch.

6. Tell the user the status line appears after the next message, and that /statusline-kit:setup can be run again to change the git option.

Do not

• Do not also run the kit's install.sh: it installs the same hooks into ~/.claude, and every run would then be recorded twice. If ~/.claude/hooks/subagent-stop.sh exists, tell the user that both are installed and that one of them has to go.
• Do not write anywhere except ~/.claude/settings.json.